Title: HYPER 7 SETTING UP
Description: SETTING UP HYPER 21 ENGINE ON HYPER 7
dye29 - June 21, 2010 10:54 PM (GMT)
HY CAN ANYONE HELP ME PLEASE I HAVE A HYPER 7 WITH A HYPER 21 8P ENGINE ,IM TRYING TO SET IT UP BUT IV GOT TO THE POINT WHERE ALL SOUNDS GOOD BUT WHEN I STOP IT TAKES ABOUT 10 SEC FOR THE ENGINE TO IDLE DOWN THEN CUTS OUT IM TOTALLY CLUELESS PLEASE HELP ITS A HOBAO HYPER 21 8P. REGARDS STE
Nitroazza - June 22, 2010 10:15 AM (GMT)
| QUOTE (dye29 @ Jun 21 2010, 10:54 PM) |
| HY CAN ANYONE HELP ME PLEASE I HAVE A HYPER 7 WITH A HYPER 21 8P ENGINE ,IM TRYING TO SET IT UP BUT IV GOT TO THE POINT WHERE ALL SOUNDS GOOD BUT WHEN I STOP IT TAKES ABOUT 10 SEC FOR THE ENGINE TO IDLE DOWN THEN CUTS OUT IM TOTALLY CLUELESS PLEASE HELP ITS A HOBAO HYPER 21 8P. REGARDS STE |
with the cutting out after 10 seconds, its the idle screw mate.
adjust it 1/8th turns clockwise to speed it up a little.
a good rule is, if you can start it and let it idle for 30 seconds then it stalls, its the low speed needle, if it stalls before that then its the idle screw mate.
dye29 - June 22, 2010 10:43 AM (GMT)
hy ill try that today and let you no how i get on thanks ,other thing i have the 1/16th gap as i look in the carb so i open it with transmitter then let go and it takes about 5 seconds to go back to place is this normal regards ste
dye29 - June 22, 2010 10:54 AM (GMT)
hy i think i have the same as you mines a tq sport lime green if so wouldnt mine run with the same settings as yours or is each engine different regards ste
Nitroazza - June 22, 2010 04:14 PM (GMT)
all engine settings i.e: lsn, hsn and idle should be the exact same, unless you have tuned yours of course.
i will find out the sheet of mine that i wrote the factory tune settings on and will tell you them.
also check your transmitter, the throttle and steering trim conrols are real easy to move out of place. check that those arent causing a problem.
:thumbs_up:
Nitroazza - June 22, 2010 04:25 PM (GMT)
right mate, found out my sheet with the factory tune settings on.
this is what your engine comes to you like, for typical running in and for general good running with no problems.
(im measuring in half turns, so 180degrees, so when i say 6 turns, it means 6 half turns, so if you measure it in full turns, its 3 full turns.)
High speed needle is.... 5 and 1:8th turn.
Low speed needle is.... 11 and 1:8th turn.
to set your engine up to this factory setting.
turn both your high speed needle and low speed needle all the way in clockwise, until the dont go anymore. then count these turns out that i have given you for factory settings.
once you have gone to these factory settings, you will then need to re-tune your engine for performance
hope this helped,
if you need idle screw setting then let me know.
:thumbs_up:
